You are here

Four-sonde induction logging tool 4IK

The tool has the following modifications by max operating temperature T max and upper value of borehole hydrostatic pressure Pmax :
  by temperature: 120, 150, 175, 200 °С,
  by pressure: 80, 100, 120, 140 МPа.
Designed for induction logging using 4 sondes that have different depth of investigation with simultaneous recording of apparent conductivity active and reactive components for every sonde. SP analog value is transmitted by the third conductor of the cable.

Used in open oil and gas holes filled with water- or oil-base mud; operates with a three-conductor carrying logging cable up to 7000 m long and log recorders that provide for command transfer and data receipt in “Manchester-2” code.

Applications:
 reservoir identification in oil and gas wells section;
 formation resistivity evaluation;
 reservoir saturation evaluation.

The tool contains four three-coil IL sondes –3I0.5, 3I0.85, 3I1.26, 3I2.05. All sondes have common receiving coil, common measuring channel and operate at the same frequency of 100 kHz.

Measured parameters Measurement range Basic error
Sonde Channel σa, mCm/m ρa, Ohm·m ±(0.03×σa+1 mCm/m)
ЗI0.5 active 3÷1500 0.3÷300
reactive 3÷1500 0.3÷20
ЗI0.85 active 3÷1000 0.3÷300
reactive 3÷1000 0.3÷30
ЗI1.26 active 3÷500 0.6÷300
reactive 3÷1000 0.3÷35
ЗI2.05 active 3÷300 1.0÷300
reactive 3÷700 0.3÷45

General specifications
Tool length, mm 3750 not more than
Tool diameter, mm 76 not more than
Tool weight, kg 40 not more than
Power supply:
supply voltage, V
supply frequency, Hz

220
50

±10%
±1%
Borehole diameter, mm 110÷350  
Logging speed, m/hr up to 1500  
Combinability feed-through  
Location in the borehole free/
with standoffs